The timer is offered with two separate relays. When power is applied, the first relay (Attempts) will energize for the set “on” time delay period, then de-energize for the set “off” time delay period. This is classed as the “first attempt”. The same relay will continue to cycle on and off for the “number of attempts” set on the adjustment. If all the attempts are allowed to run, at the end of the last “on” time delay period, the first relay will de-energize and the second relay (Alarm) will energize and remain in this state. Power must be removed and re-applied to restart the function over again.
Multi Attempt to Start
Designed to limit the number of attempts an engine has to start before providing an alarm
Selectable number of attempts (2-8)
Multi-voltage (12 -48VAC/DC)
Single time range (1 - 60s)
2 x SPDT Relay outputs
17.5mm wide, DIN Rail mount
| 屬性 | 數值 |
|---|---|
| 電源電壓 | 12 → 48V 交流/直流 |
| 安裝類型 | DIN 導軌 |
| 觸點數 | 1 |
| 時間范圍 | 1 → 60s |
| 計時器功能數目 | Multi Attempt to Start, 單 |
| 計時器功能數目 | Multi Attempt to Start, 單 |
| 觸點配置 | 單刀雙擲 |
| 時間增量 | 秒 |
| 最大電壓 | 48V 交流/直流 |
| 最大電流 | 8A |
| 系列 | LMAT |
| 電源 | 外部 |
| 端子類型 | 螺釘 |
| 最小電壓 | 12V 交流/直流 |
| 深度 | 89mm |
| 開關配置 | 2 x SPDT |
| 寬度 | 66.5mm |
| 最高工作溫度 | +60°C |
| 長度 | 17.5mm |
